kiddswivle17632 kiddswivle17632

03-03-2020
Computers and Technology

contestada

You need to connect a workstation to a switch using a regular port on the switch (not an uplink port). The switch does not support auto- MDI. Which type of cable should you use.

Respuesta :

SerenaBochenek SerenaBochenek

03-03-2020

Answer:

The correct answer to the following question will be "Straight-through ".

Explanation:

It's a kind of twisted-pair wire used for interact a device to a networking center like a modem or router in LAN.

By linking two separate kinds of connected devices, use this cable.
This connection is often applied to this as a repaired cable, too.

So, it's the right answer.

Answer Link

Otras preguntas

The distances from Frisco, Texas to Lincoln, Nebraska is 621 miles. if a driver averages 51.75 miles per hour, approximately what is the shortest time it can ta

at the beginning of the nineteenth century, social reformers in the Britain began pressing nuns and other religious groups to provide nursing care in the growin

Simplify 5d (7-3) -16d + 3 x 2d A) 10d B) 14d C) 21d D) 25d Please explain and show work!!

Why did the scientific revolution occur in europe?

Please help me idk this

Babylonian Law Hammurabi code It is apparent that the Hammurabi code is the product of a civilization rather than some other kind of early society? Does the co

Where in the human body would you find the most mitochondria?

4-(3/4. 4/3) Math q

a photographer wants to enlarge a 5x7 photo for a wall mural without distorting its width-to- length ratio. What are the largest dimensions to which he can enla

What is the slope of the line shown below