Read the PIC Data sheet Chapter 2.0 and 3.0 2. List at least 3 big differences between the Flash and RAM 3. How many RAM locations are there and how many bits in each location 4. How many Flash locations are there and how many bits in each location 5. Based on the diagram in figure 2-1, what memory are the configuration words associated with 6. In section 3.5.2 there is a description of Linear Data Memory". This is accessed using indirect addressing via the registers FS0 or FSland it allows one to have an array or buffer that is more than 80 bytes long. Explain why this is needed. 7. When you access data RAM, you must always make sure that the BSR is pointing to the right memory bank if you are using the normal mode of direct addressing. Are there any locations in data RAM where you don't have to worry about having the right bank selected? Explain your answer.